This tube is an improvement over the stock E3D HeatBreak. It’s made from stainless steel and plated with TwinClad XT coating. TwinClad XT is a very low friction Electroless Nickel composite coating, often used in injection molding because of it release properties. This high lubricity plating will prevent clogging in the critical zone of hotend, where filament liquidizes. It is also very hard and corrosion resistant. Great for high abrasion filaments like Carbon Fiber, Metal filled, Aluminates, etc.Fits: E3D v6 1.75mm Direct and Bowden HotEnds
Plated with TwinClad XT Coating (Low Friction, High Lubricity)
Thread size on heater block side : M6x1 Therad size on heatsink side: M7x1
Stepped inside bore to improve PLA printing.
Made in USA by Micro Swiss