$25.00 - $15.99
RAMPS 1.Four Controller Board
Replace Excessive High quality Ramp Board by altering MOSFET:
Outdated MOSFET IC Mannequin : PDF55N06; Specification: VDSS: 60V; ID:55A
New MOSFET IC mannequin: HM60N06; Specification: VDSS: 60V; ID: 60A
HM60N06 present as much as 60A,Extra security
Expandable to regulate different equipment.
three Mosfets for heater / fan outputs and three thermistor circuits.
Fused at 5A for added security and part safety
Heated mattress management with further 11A fuse.
Matches 5 Pololu stepper driver boards.
Pololu boards are on pin header sockets to allow them to get replaced simply or eliminated to be used in future designs.
I2C and SPI pins left accessible for future enlargement.
All of the Mosfets are hooked into PWM pins for versatility.
Servo type connectors are used to hook up with the tip stops, motors, and LEDs. These connectors are rated for 3A, very compact, and globally accessible.
SD Card add on accessible.
LEDs point out when heater outputs on.
Choice to attach 2 motors to Z for Prusa Mendel.
Easy step and route management interface.
Can interface immediately with three.three V and 5 V methods.
Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout.
Six totally different step resolutions: full-step, half-step, 1/Four-step, 1/Eight-step, 1/16-step, and 1/32-step.
Adjustable present management enables you to set the utmost present output with a potentiometer, which helps you to use
voltages above your stepper motor’s rated voltage to realize increased step charges.
Clever chopping management that routinely selects the proper present decay mode (quick decay or gradual decay)
45 V most provide voltage.
Constructed-in regulator.(no exterior logic voltage provide wanted)
Package deal embody:
1 * RAMPS 1.Four controller board
5 * A4988 Step stick Driver
5 * Warmth Sink
Versatile: 1pcs RAMPS 1.Four Controller Board+ 5pcs A4988 Stepstick Stepper Motor Driver Module with Warmth Sink in your Arduino-compatible MEGA protect for straightforward service, half alternative, upgrade-ability and enlargement.
RAMPS 1.Four enlargement board as a driver enlargement board, can be utilized for engraving machines, 3D printers and it’s a whole of 5 slots, can drive 5 A4988 stepper motor.
Replace Excessive High quality Ramp Board by altering MOSFET: previous MOSFET IC Mannequin : PDF55N06 * Specification：VDSS:60V ID:55A New MOSFET IC mannequin: HM60N06 Specification：VDSS:60V ID:60A HM60N06 present as much as 60A，Extra security Every highway stepper motors solely want two IO ports.
Stepper motor wiring as follows: 2A, 2B is a bunch (purple, inexperienced), 1A, 1B is a bunch (blue, yellow), if need to change route, may be change the place of 1 group , for instance 2A, 2B mutually exchanged.
Utilizing This suite (1pcs RAMPS 1.Four Controller Board+ 5pcs A4988 Stepstick Stepper Motor Driver Module with Warmth Sink in your Arduino-compatible MEGA protect for straightforward service,half alternative,upgrade-ability and enlargement.