BIQU 3D Printer Half Extremely Silent TMC2208 V1.zero Stepper Motor Driver Module with Heatsink for Management Board MKS GEN V1.four Ramps 1.four Ramps 1.6 (Pack of 5pc)

3,299.00$

Description

Worth: $32.99

Specification :
Interface: Step/Dir
Configuration: CFG Pins or UART
Microplyer/ Microsteps:as much as 1/256
Logic Voltage VIO: Three-5V
Motor Voltage VM: 5.5V-36V
Motor Section Present: 1.2A RMS,2.0A Peak
VM at all times wanted: Sure
Inner V-Regulator: enabled
RDSon: Lower than and equal to zero.Three Ohm
StealthChop(quiet):YES
SpreadCycle: YES
CoolStep: no
StallGuard: no
DcStep: no

Directions:
1. When used on Ramps1.four or MKS Gen,please take away the three jumpers below socket.
2. Take note of route, don’t insert wrongly.
Three. Warmth sink straight connect on the PCB.
four. The motor route is reverse to that of 4988 and 8825, please modify the firmware or modify the motor wiring if you wish to substitute 4988.

Packing Checklist:
5x TMC2208 Driver
5 x Warmth Sink

Versatile microPlyer interpolation unit, the part can present as much as 256 microsteps/step decision. Even within the restricted pulse charge system, it could nonetheless have the ability to obtain sinusoidal management.
As a result of stealthChop superb sound know-how is broadly utilized in 3D printing, these elements are additionally designed to be suitable with present 3D printer electronics, saving the necessity for expensive redesign. Each elements have pulse/ route enter, and it may be fully unbiased operation. The configuration is applied through digital enter.
Based mostly on TRINAMIC TMC 2100 two-phase motor, stepper motor drive board, TRINAMIC TMC 2130 or TRINAMIC TMC 2208, it’s suitable with stepstick and pololu a4988 .
SpreadCycle excessive chopper frequency, dcStep, stallGuard2 stall detection know-how.
CoolStep present dynamic adjustment know-how, it could save 70% of the power, StealthChop mute.