(as of Jan 04, 2024 12:31:13 UTC – Details)
<
（Ender 3 Thermistor, Upgrade HT-NTC100K Thermistor (1 meter each)）：Cartridge temperature sensor. Metal head diameter: 3mm, head length: 15mm,cable wire length: 1 meter,connector: XH2.54 2PIN, （Suitable for heating blocks with holes of 3mm*15mm-3mm*20mm）
Compatibility：Product recommended operating temperature -50 °C ~ +280 °C, can replace the cartridge K-type thermocouple temperature sensor. Suitable to print multi kinds of filament.Compatible with the heatblocks with 3mm hole,such as: V6 Volcano PT100 type heated block,CR10 plated copper high temperature heating block,etc
Compatible with E3D V6 Volcano PT100 Ender 3, Ender 3 v2, Ender 5 , Ender 5 Pro, CR10 CR-10S 3D Printer etc; These sensors to be highly accurate, the best feature was the flexible and heat shielded probe leads to the copper sensor. Unlike the other ones you see with a nickel plated probe/heat shrink, this can be fitted in very tight spots without worry. Very accurate. Be sure you redo your PID calibration.
Long Service Life：Compared with other products of the same type that are insulated with ordinary heat shrinkable tubes, this product uses glass fiber with a temperature resistance of 400C degrees for insulation to avoid the possibility of thermal short circuit during high temperature work. Thereby increasing the service life.
Please Notice：After the product has been opened and left in the air for a long time, the copper metal part may change color, which is normal.
